Re: [ic] Getting "default shipping" to reload after an address_book

[Mike Heins <suppressed>]

Quoting Brian Kaney (suppressed):
> I've been trying this one for hours and can't figure it out.  I've
> loaded an address using:
> 
> [userdb function="get_shipping" nickname="alternate_shipping_2"]
> 
> So the [value address1] and [value address2] are from my serialized data
> from the userdb.address_book column, which is great.  
> 
> 
> 
> Question: How do I then reload/revert to the "default" shipping data
> (i.e. userdb.address1, userdb.address2, etc) after an address book has
> been loaded?
> 
> 
> 
> I've tried unsuccessfully tried these revert:
> 
> [userdb function="get_shipping" nickname=""]
> [userdb function="get_shipping"]
> 
> My last ditch effort is to manually override the values in a big
> [set][/set], but there must be a built-in way I've missed!
> 

Can't do it for just the shipping values unless you first save
a "default" setup. If you don't mind overwriting every value that
has not been saved....

    [userdb function=get_values]

-- 
Mike Heins
Perusion -- Expert Interchange Consulting    http://www.perusion.com/
phone +1.765.647.1295  tollfree 800-949-1889 <suppressed>

p.s. sorry for lower case, injured hand

How far can you open your mind before your brains fall out?
_______________________________________________
interchange-users mailing list
suppressed
http://www.icdevgroup.org/mailman/listinfo/interchange-users